SELFIE Mavic Dual

The ROBOTERWERK SELFIE Mavic Dual is fitted to the drone with anti-slip rubber bands. The LED lamps must be activated before take-off. 

Step by step: For easy fitting, lay the drone on its back. Then place the frames (with the lamps pointing upwards) between the rotor arms, so that the rubber bands can hang down freely at the inner side of the arms. Use the ornamental strips on the front as guiding point to find the correct position.

Pull the rubber bands under the arm and guide it up to slip into the hook at the front of the frame.

If necessary, align the frames until they are in a parallel position. The rubber bands keep the frames in a skid-proof position during flight but allow for easy adjustment. 

CAUTION: To ensure a well-balanced flight, it is vital that you always attach both frames. A unilateral weight on the drone leads would lead to poor controllability and considerably reduce the flight duration.

 

LED lamp TUBE:

Press the button once: Constant light with 1 lumen

Press twice in short succession: Constant light with 45 lumen

Press and hold: temporary light with 45 lumen until you let go

When the light is turned on, press and hold the button to change the brightness step by step.

Lock out: When the light is turned on, hold the button for 3 seconds, until the light flashes. The lamp is now locked. Press again for 3 seconds to unlock.

Maximum output: 1 hour at 45 lumen, 48 hours at 1 lumen

Reload via micro USB.