M.O.N.A. Mavic

The ROBOTERWERK M.O.N.A. Mavic is fitted to the drone with anti-slip rubber bands. The LED lamp must be activated before take-off.

Step by step: For easy fitting, hold the frame up behind the front rotor arms.

Pull the rubber bands under the arm and guide it up to slip over the mounting head at the top of the frame. The frame should now sit at the back of your drone’s front arms.

The rubber bands keep the frame in a skid-proof position and dim vibrations during flight. 

 

LED lamp TINI:

TINI has two modes:

1. Temporary Mode: The light will switch off after 30 seconds.
2. Drone Mode: The light will stay on until manually switched off.

Switching between modes:

Press both buttons simultaneously to switch between the two modes. The lamp will confirm the switch by flashing. One flash: Temporary Mode activated. Two flashes: Drone Mode activated.

Press and hold the On/Off-Button for 2 seconds to switch on the light. Press for switching off.

Brightness levels:

When the light is active, press the Mode-button to switch through the brightness levels (low – mid – high).

The memory function allows the TINI to switch on again at the last brightness level that was active before shutting down.

If the buttons flash blue, the TINI battery is low.

Battery levels:

When the lamp is switched off, press the Mode button to show battery levels:

3 flashes: more than 50%
2 flashes: less than 50%
1 flash: less than 10%

To reload TINI, connect it via micro USB to a power source. A full charge takes about 2 hours.

The button illumination indicates the loading state. Continuous blue light indicates a complete charge.

CAUTION: Never shine the light in your or others‘ eyes, as it may cause blindness.